Jopa P 124 is the ideal ring cutter for the workshop and assembly.
The machine cuts all cuttable materials such as rubber, leather, felt, cardboard, plastic, graphite with a smooth foil insert and many more cleanly, accurately and with a straight cutting edge.
Technical data:
Ø range:
P 124-300: 30mm - 300mm
P 124-600: 30mm - 600mm
P 124-1000: 30mm - 1000mm
Max. Cutting thickness: 20mm
For first use, the cutter locating unit will be guided from below through the hole arranged at the centre of the cutting table, and then fastened underneath the table board.
A hole of 8 mm diameter will be provided in the material to be cut. After setting the knife to the desired diameter by means of the steel rule, the cutting arm has to be fastened to the stud bolt projecting through the material. Depending on the material to be cut, the knife bar is passed around the spindle several times with adapted hand pressure, until the material is completely severed.
[Due to technical developments, all illustrations and dimensions are non-binding]
Order no. 451
Cutting blade made of tool steel (standard blade)
for rubber and similar soft materials
Order no. 452
Carbide cutting blade
for e.g. fiber materials, graphite with and without inserts and all materials where a long service life is required.
Order no. 453
Cutting wheel with holder for all materials where unrolling the cutting wheel is advantageous, e.g. very soft or thin rubber types (smallest cutting diameter limited!)
Order no. 1354
Cutting wheel without holder Spare part for order no. 453
Order no. 455
Chipping knife made of tool steel for chipping e.g. hard plastics and other machinable materials
Order no. 124-04
Small set of hold-down plates for holding the cutting material in the area of the cutting diameter when the pressure of the spindle is not sufficient, especially with very soft and very hard materials.
4 pieces from 100-250mm diameter
Order no. 124-10
Large set of hold-down plates for holding the cutting material in the area of the cutting diameter when the pressure of the spindle is not sufficient, especially with very soft and very hard materials.
10 pieces from 100-550mm diameter