The machine FRIPA P 125 cuts rubber, fibers, leather, felt, cardboard, plastics and all cuttable materials (e.g. graphite with VA insert).
The machine cuts: Hard plastics and soft metals.
Technical data:
Ø range:
P 125-302: 30mm - 300mm
P 125-602: 30mm - 600mm
Max. Cutting thickness: 20mm
Inside and outside cut simultaneously
The FRIPA P 125 machine is used for fast cutting of gaskets, rings and sheets from the materials listed above. With this machine, the inner and outer cuts are performed in a single operation.
The cutting material is clamped by means of a clamping spindle, so there is no need to make a hole in the center of the cutting material. Fixed scales are provided on the blade carrier for precise and fast adjustment of the cutting tools. A few turns are enough to produce a clean and perfect cut. The machine is simple and easy to operate.
By using the additional tools offered, all the materials listed can be cut perfectly.
[Due to technical developments, all illustrations and dimensions are non-binding]
Order no. 451
Cutting blade made of tool steel (standard blade)
for rubber and similar soft materials
Order no. 452
Carbide cutting blade
for e.g. fiber materials, graphite with and without inserts and all materials where a long service life is required.
Order no. 453
Cutting wheel with holder for all materials where unrolling the cutting wheel is advantageous, e.g. very soft or thin rubber types (smallest cutting diameter limited!)
Order no. 1354
Cutting wheel without holder Spare part for order no. 453
Order no. 455
Chipping knife made of tool steel for chipping e.g. hard plastics and other machinable materials
Order no. 45-04
Small set of hold-down plates for holding the cutting material in the area of the cutting diameter when the pressure of the spindle is not sufficient, especially with very soft and very hard materials.
4 pieces from 100-250mm diameter
Order no. 45-10
Large set of hold-down plates for holding the cutting material in the area of the cutting diameter when the pressure of the spindle is not sufficient, especially with very soft and very hard materials.
10 pieces from 100-550mm diameter